LxCenter HyperVM & Kloxo Support

Forum



Members   Search      Help    Register    Login    Home
Home » Kloxo Community Support » First Time Users » enable exec?
enable exec? [message #97399] Thu, 05 April 2012 07:16 Go to next message
natostanco is currently offline natostanco  Italy
Messages: 4
Registered: March 2012
Member
Safe mode is off, and exec and shell_exec are not present among the disabled functions, with lighttpd I can run commands but with httpd I can't...what does httpd need more than this?
Re: enable exec? [message #98103 is a reply to message #97399] Wed, 09 May 2012 18:47 Go to previous messageGo to next message
Elsys is currently offline Elsys  United States
Messages: 46
Registered: January 2012
Location: Pleasentville, PA
Member
it doesn't its a hiccup in the system should clear itself up after some time. I had the same thing happen to my curl function when I was managing icecast2 on a site. Not sure what causes that though.
Re: enable exec? [message #98104 is a reply to message #98103] Wed, 09 May 2012 19:35 Go to previous message
shazar is currently offline shazar  United States
Messages: 1856
Registered: May 2011
Grandmaster
LxCenter Core Team Member
LxCenter Representative
If service httpd reload won't help try a stop and start.

https://www.mercuryvps.com
HyperVM Xen VPS hosting
Previous Topic:add ipv6 to kloxo and dns
Next Topic:How do I backup http raw access logs for Users accounts
Goto Forum:
  


Current Time: Thu May 23 02:36:52 EDT 2013

Total time taken to generate the page: 0.01052 seconds
.:: Contact :: Home :: Privacy ::.

Click here to lend your support to: LxCenter and make a donation at www.pledgie.com !

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software